Total: R0.00
Total: R0.00

E3D V5 J-Head – All Metal Hot End- 12V- Direct Drive Kit

Original price was: R258.75.Current price is: R132.25. INC VAT

1 in stock


E3D V5 J-Head – All Metal Hot End for Direct Drive Printers

This hot end is not manufactured by E3D, but is the generic version.

This hot end is a hybrid between the J-head hot end and the All Metal hot end, because it has the sturdy metal structure of the All Metal hot end with a cooling fan and the easy to use internal structure of the J-Head hot end with the high temperature PTFE liner. It uses a fan to constantly blow over the cooling fins to cool down the hot end quickly enough for accurate printing. This is a easy to use, high quality hot
end and has been tested with ABS, PLA, Nylon, PC and Flexible filament and up to a temperature of 300 Deg C.

This hot end comes with cooling fan, heater cartridge and thermistor, it is for 1.75mm Filament and comes with a 0.4mm Nozzle
It comes installed with a 12V fan and bracket for cooling as well as a 40W heater cartridge and 100k thermistor with leads.

Note: It is possible that the hot end might leak plastic at the heater block when it is used for the first time. This is because the nozzle
was tightened at room temperature and when the hot end is heated up to printing temperature, a small gap is created between the nozzle and
the heat break.  To solve this, loosen the grub screw that locks the nozzle (if present) and heat the hot end to printing temperature.
Hold the heater block with pliers and tighten the nozzle with a spanner a little bit at a time so that the nozzle seats on the heat break.
When done, tighten the grub screw onto the nozzle again.


1  x  Complete E3D V5 J-Head – All Metal Hot end Kit
1  x  Cooling Fan – 12V
1  x  Cooling Fan Bracket
1  x  Printer Nozzle – 0.4mm
1  x  Heater Cartridge – 12V – 40Watt
1  x  Thermistor – 100K with Leads

Additional information

Weight 0.1 kg