Description
Use this adapter, no need of cutting the wires!
Simply connect between the board and the cable, connect 3 for bltouch wires and upgrade the firmware.
Improve design with wider power channels
Easy and convenient to use, easy to operate
The motherboard is safe and stable, and the line is clear.
Specification:
Compatible: for Ender3/Ender 3 Pro/Ender5/CR-10 Mini/CR-10
Not compatible with: for ANET A8/Ender2/Ender4/CR-8
Colour: Green
Packing list:
1 x BL Touch Pin 27 Adapter Board
Note:
The pin 27 plate makes it quick and easy to install a bltouch or filament sensor.
Usually you need to cut the ribbon cable and solder it to pin 27,
But the board should be able to plug and unplug. (after firmware update)
Be sure to check the wire configuration on the bltouch or filament sensor.
The new bltouch sensor should be plugged directly into the board without disengaging the connector.
From left to right: brown ground, red -5v, yellow / orange signal
Disconnect the LCD ribbon ext1 on the control board
Connect Ext1 to pin 27 board
Connect bltouch to the 3 pins on the pin 27 board. From left to right: brown ground, red -5v, yellow signal
Connect pin 27 to the motherboard. Be sure to align the plug pins on plug 27 with the motherboard.
